Problem

How does the floor work?

       First, the joints from the drums

       A, the floor surface of the water: the installation process, it is inevitable that sometimes the glue is not completely fill the joints. If the towing towing dripping water will cause the floor surface of the water and from the suture into the less seam, the floor substrate will absorb moisture, resulting in local expansion and has a small bubble phenomenon. In this case, the surface of the floor is partially bulged;

       B, the bottom of the floor into the water from the drum: the surface phenomenon for the seams bulging shape is more uniform, from the water near the place more severe, far more and more peaceful place. Where there are such problems are: near the bathroom, kitchen, heating pipes, air conditioning, condensate drain, windows and so on. Such as flooding a long time, the surface phenomenon is not obvious, you can open the floor to check whether there is a watermark to determine the reasons;

       C, the floor short seam from the drum: the performance of the long floor of each short side of the floor are from the drum, usually caused by too much moisture on the ground. The higher the drums, the greater the ground moisture.

       Maintenance program: replace the floor.

       Second, the floor from the arch

       Surface phenomena are stepped up to have a sense of suspension, individual places will be more serious.

       A, expansion joints reserved for the floor from the arch;

       B, the room through the shop: more than two rooms in the installation of the floor when the door do not install the buckle, in the moisture, the greater the two rooms when the floor of the horizontal extension of the floor, causing the room at the door of each other involved, so that the floor from the arch;

       C, expansion joints were nailed to death or plaster, putty, etc. to fill, so that the floor can not stretch, resulting in the floor from the arch;

       D, the installation process, there are foreign body to stay in the floor, resulting in arch;

       E, floor under the grass from the arch, such as the installation of the floor before the original solid wood flooring, after the floor after the original floor damp from the arch, resulting in the floor was arched;

       Repair the program: from the skirting board, once again set the expansion joints; in the room and the room connection to install the buckle; re-install the baseboard, clean up the plaster, putty and other reserved expansion joints; from the floor, Out of the floor, the ground treatment is flat, dry and then pave the floor again.

       Third, the floor cracks

       A, uneven ground: the ground is not smooth in the case of paving the floor, after a period of time, the floor between the glue off the gap;

       B, less sizing: the floor in the winter, there is heating baking, air drying, floor plane contraction, seams glue shortage, strength is not enough, so that the floor open plastic cracks;

       C, the side of the weight: the need to repair the floor parallel to the direction of the heavy pressure, so that the floor can not be free to shrink, resulting in cracks; this room will appear in the summer arch phenomenon, and winter heating when there will be cracks phenomenon;

       Maintenance program: remove the floor, the ground treatment is flat, dry and then paved; according to the size of the crack, decided to fill wax, re-irrigation; with special tools fixed or reload; remove heavy objects, re-irrigation fixed.

       Fourth, the surface defects

       A, corner: the floor in the handling process bumps, the construction staff in the construction process did not pay attention to or after the construction of clean up the glue when the shoveling, so that the corner of the corner of the phenomenon;

       B, the surface off: after the construction, the weapon or heavy objects fell to the ground floor, so that the floor is affected; or floor processing, the surface and the substrate is not gluing good, after a period of time, the surface and the substrate degumming;

       C, scratches: the customer on the floor when the furniture or heavy objects, the floor and the items mixed with nails or sand and other debris, drag on the floor caused by damage to the floor wear layer or obvious scratches;

       Repair program: wax block repair or replace the floor. First, the joints from the drums

       A, the floor surface of the water: the installation process, it is inevitable that sometimes the glue is not completely fill the joints. If the towing towing dripping water will cause the floor surface of the water and from the suture into the less seam, the floor substrate will absorb moisture, resulting in local expansion and has a small bubble phenomenon. In this case, the surface of the floor is partially bulged;

       B, the bottom of the floor into the water from the drum: the surface phenomenon for the seams bulging shape is more uniform, from the water near the place more severe, far more and more peaceful place. Where there are such problems are: near the bathroom, kitchen, heating pipes, air conditioning, condensate drain, windows and so on. Such as flooding a long time, the surface phenomenon is not obvious, you can open the floor to check whether there is a watermark to determine the reasons;

       C, the floor short seam from the drum: the performance of the long floor of each short side of the floor are from the drum, usually caused by too much moisture on the ground. The higher the drums, the greater the ground moisture.

       Maintenance program: replace the floor.

       Second, the floor from the arch

       Surface phenomena are stepped up to have a sense of suspension, individual places will be more serious.

       A, expansion joints reserved for the floor from the arch;

       B, the room through the shop: more than two rooms in the installation of the floor when the door do not install the buckle, in the moisture, the greater the two rooms when the floor of the horizontal extension of the floor, causing the room at the door of each other involved, so that the floor from the arch;

       C, expansion joints were nailed to death or plaster, putty, etc. to fill, so that the floor can not stretch, resulting in the floor from the arch;

       D, the installation process, there are foreign body to stay in the floor, resulting in arch;

       E, floor under the grass from the arch, such as the installation of the floor before the original solid wood flooring, after the floor after the original floor damp from the arch, resulting in the floor was arched;

       Repair the program: from the skirting board, once again set the expansion joints; in the room and the room connection to install the buckle; re-install the baseboard, clean up the plaster, putty and other reserved expansion joints; from the floor, Out of the floor, the ground treatment is flat, dry and then pave the floor again.

       Third, the floor cracks

       A, uneven ground: the ground is not smooth in the case of paving the floor, after a period of time, the floor between the glue off the gap;

       B, less sizing: the floor in the winter, there is heating baking, air drying, floor plane contraction, seams glue shortage, strength is not enough, so that the floor open plastic cracks;

       C, the side of the weight: the need to repair the floor parallel to the direction of the heavy pressure, so that the floor can not be free to shrink, resulting in cracks; this room will appear in the summer arch phenomenon, and winter heating when there will be cracks phenomenon;

       Maintenance program: remove the floor, the ground treatment is flat, dry and then paved; according to the size of the crack, decided to fill wax, re-irrigation; with special tools fixed or reload; remove heavy objects, re-irrigation fixed.

       Fourth, the surface defects

       A, corner: the floor in the handling process bumps, the construction staff in the construction process did not pay attention to or after the construction of clean up the glue when the shoveling, so that the corner of the corner of the phenomenon;

       B, the surface off: after the construction, the weapon or heavy objects fell to the ground floor, so that the floor is affected; or floor processing, the surface and the substrate is not gluing good, after a period of time, the surface and the substrate degumming;

       C, scratches: the customer on the floor when the furniture or heavy objects, the floor and the items mixed with nails or sand and other debris, drag on the floor caused by damage to the floor wear layer or obvious scratches;

       Repair program: wax block repair or replace the floor.


Jianwowei wood co., Ltd Copyright Copyright 2017 All Right Reserved

Address:Tianchang City Branch Jian Industrial Park District A Tel:0550-2389908 Fax:0550-2388790

Visits: